To make a DIY concrete lamp base you’ll need:
- 200g concrete
- 100ml of water
- a knife or something similar to mix
- sanding paper
- an old lamp base
- washi tape
- a cup
In your cup start by mixing concrete and water, stirring well. Add small amounts of water at a time until you get a tough dough similar to play dough. Then spread amounts of concrete on the surface of the lamp trying to go as even as possible. Place your lamp base on washi tape so it won’t touch the workspace. Because of my weird shaped lamp base I had to put a lot of concrete to fill the holes. Keep on going until you cover everything and once you’ve done, take a couple of mins to smooth all over the surface another time. Let dry for the night.
You can see the concrete is ready for sanding when it all becomes light grey and some crackles appear. Go ahead and sand it, assemble all the lamp pieces together and you’re done!
Now some considerations about concrete in diy projects. Personally I’m not so happy about the result, mainly because of the big crackles that appeared when dried. Just after the craft I discovered that if you use concrete on vertical smooth surfaces the problem is it can’t grip well and it cracks down. The solution is adding a gridded layer to the base, so things like a gauze will work I think. Also another trick I discovered AFTERWARDS is that to smooth the surface you can rub gently a damp sponge whilst the concrete is still wet. Fine then, next concrete project will be far better then. We make mistakes for this reason right? 😉
Lots of love,
Chiara
In ogni caso, per realizzare una lampada da tavolo con base in cemento, vi servirà:
- 200g cemento
- 100ml acqua
- un coltello o qualcosa di simile per mischiare
- carta vetro
- la base di una vecchia lampada
- nastro di carta
- tazza o bicchiere
Nella tazza mischiate cemento e acqua, mescolando bene. Aggiungete l’acqua un poco alla volta finché non diventa una pasta simile al pongo. Ora cospargete la lampada col cemento, cercando di renderla più liscia possibile. Vi consiglio di appoggiare la lampada sul nastro di carta per non farle toccare il tavolo. A causa della strana forma della mia lampada ho dovuto mettere grandi quantità di cemento nei solchi. Continuate finché non ricoprite tutto. Prendetevi ancora qualche minuto per uniformare ulteriormente la superficie e lasciate asciugare tutta la notte.
Il cemento è asciutto quando diventa tutto grigio chiaro e si formano delle piccole crepe sulla superficie. Ora potete passare la carta vetro, ri-assemblare la lampada e abbiamo finito!
Ed eccoci al momento delle riflessioni sul cemento nei progetti di fai-da-te. Personalmente non sono molto soddisfatta del risultato a causa delle piccole crepe che si sono formate durante l’ asciugatura. Solo dopo aver ultimato il progetto ho scoperto che il problema è che il cemento applicato in verticale su superfici morbide come la plastica ha difficoltà a fare presa e tende naturalmente a creparsi. La soluzione potrebbe essere quella di aggiungere una base a griglia, ad esempio una garza. Un’altra cosa che ho scoperto solo DOPO aver fatto il lavoro è che si può allisciare ulteriormente la superficie passando una spugna umida prima dell’asciugatura. Beh, ora che ho tutte queste info in più sono certa che il prossimo progetto con questo materiale verrà sicuramente meglio. Sbagliando si impara, no? 😉
Con affetto,
Chiara
New here? Discover what else we’re creating.
And don’t forget to follow One O on Facebook, Instagram, Pinterest or Bloglovin <3
Tags: base bed bedroom decor home lamp makeover table workspace